User`s guide

ericom D1000 modem User’s Guide 195
CHAPTER 24
Remote Management
24.1 Overview
Remote management allows you to determine which services/protocols can access which Device
interface (if any) from which computers.
The following figure shows remote management of the Device coming in from the WAN.
Figure 133 Remote Management From the WAN
Note: When you configure remote management to allow management from the WAN, you
still need to configure a IP filter rule to allow access.
You may manage your Device from a remote location via:
• Internet (WAN only)
•LAN only
•LAN and WAN
• None (Disable)
To disable remote management of a service, select Disable in the corresponding Service Access
field.
24.1.1 What You Can Do in the Remote Management Screens
•Use the WWW screen (Section 24.2 on page 196) to configure through which interface(s) and
from which IP address(es) users can use HTTP to manage the Device.
•Use the Telnet screen (Section 24.3 on page 198) to configure through which interface(s) and
from which IP address(es) users can use Telnet to manage the Device.
•Use the FTP screen (Section 24.4 on page 199) to configure through which interface(s) and from
which IP address(es) users can use FTP to access the Device.
LAN
WAN
HTTP
Telnet