User`s guide

Chapter 21 Log Setting
ericom D1000 modem User’s Guide
188
The following table describes the fields in this screen.
Table 77 Maintenance > Log Setting
LABEL DESCRIPTION
Active Select the Active check box to enable logging.
Mode Select the syslog destination from the drop-down list box.
If you select Local File, the log(s) will be saved in a local file. If you want to send the
log(s) to a remote syslog server and save it in a local file, select Local File and
Remote.
E-mail Log Settings (The following fields will display if you select Local File and Remote in the Mode field.)
SMTP
Authentication
SMTP (Simple Mail Transfer Protocol) is the message-exchange standard for the
Internet. SMTP enables you to move messages from one E-mail server to another.
Select the check box to activate SMTP authentication. If mail server authentication is
needed but this feature is disabled, you will not receive the E-mail logs.
Mail Server Enter the server name or the IP address of the mail server for the e-mail addresses
specified below. If this field is left blank, logs and alert messages will not be sent via E-
mail.
Mail Subject Type a title that you want to be in the subject line of the system log e-mail message
that the Device sends.
From Specify where the logs are sent from.
To The Device sends logs to the e-mail address specified in this field. If this field is left
blank, the Device does not send logs via E-mail.
User Name Enter the user name (up to 32 characters) (usually the user name of a mail account).
Password Enter the password associated with the user name above.
Log Schedule Specify the schedule for sending log. Specify days and times for sending logs in the
following fields.
Day For Sending
Log
Specify the day for sending log.
Time for Sending
Log
Specify the time for sending log.
Clear log after
sending mail
Select this to delete all the logs after the Device sends an E-mail of the logs.
Syslog Settings (The following fields will display if you select Local File and Remote in the Mode field.)
Syslog Server IP
Address
Enter the server name or IP address of the syslog server that will log the selected
categories of logs.
Syslog Server UDP
Port
Enter the port number used by the syslog server.
Active Log and Alert
Log Category Select the categories of logs that you want to record.
Log Level Select the log level. See Chapter 16 on page 173 for descriptions of log levels.
Apply Click Apply to save your changes.
Cancel Click Cancel to restore your previously saved settings.