User`s guide

Chapter 10 Port Isolation
ericom D1000 modem User’s Guide
136
If a WAN PVC is bound to an Ethernet port, traffic from the Ethernet port will only be forwarded
through the specified WAN PVC and vice versa. If a port is not in a port isolation group, traffic to
and from the port will be forwarded according to the routing table.
10.1.1 What You Can Do in the Port Isolation Screens
•Use the General screen (Section 10.3 on page 136) to activate port isolation.
•Use the Port Isolation screen (Section 10.3 on page 136) to set up port isolation groups.
•Use the Port Isolation Summary screen (Section 10.3.1 on page 137) to view configured port
isolation groups.
10.2 The Port Isolation General Screen
Use this screen to activate port isolation and set up port isolation groups. Click Network Setting >
Port Isolation to display the following screen.
Figure 93 Network Setting > Isolation
The following table describes the labels in this screen.
10.3 The Port Isolation Screen
Use this screen to set up port isolation groups. Click Network Setting > Port Isolation > Port
Isolation to display the following screen.
Table 49 Network Setting > Port Isolation
LABEL DESCRIPTION
Activated Port
Isolation
Activate or deactivate the port isolation feature.
Apply Add the selected port isolation group configuration.