User`s guide

Chapter 8 Quality of Service (QoS)
ericom D1000 modem User’s Guide
121
8.5 The QoS Game List Screen
Use this screen to give priority to traffic for specific games. Click Network Setting > QoS > Game
List to open the screen as shown next.
Figure 84 Network Setting > QoS > Game List
IP Precedence
Mark
Enter a range from 0 to 7 to re-assign IP precedence to matched traffic. 0 is the lowest
priority and 7 is the highest.
Type Of
Service Mark
Select a type of service to re-assign the priority level to matched traffic.
Available options are: Normal service, Minimize delay, Maximize throughput,
Maximize reliability and Minimize monetary cost.
DSCP
Mark(0~63)
This field is available only when you select IP in the Ether Type field.
If you select Mark, enter a DSCP value with which the Device replaces the DSCP field in
the packets.
If you select Unchange, the Device keep the DSCP field in the packets.
802.1Q Tag If you select Remark, select a priority level (in the Ethernet Priority field) and enter a
VLAN ID number (in the VLAN ID field) with which the Device replaces the IEEE 802.1p
priority field and VLAN ID of the frames.
If you select Remove, the Device deletes the VLAN ID of the frames before forwarding
them out.
If you select Add, the Device treat all matched traffic untagged and add a second priority
level and VLAN ID that you specify in the Ethernet Priority and VLAN ID fields.
If you select Same, the Device keep the Ethernet Priority and VLAN ID in the packets.
To configure the Ethernet Priority, you can either select a priority number in the first
drop-down list box (7 is the highest and 0 is the lowest priority) or select an application
from the second drop-down list box which automatically maps to the corresponding
priority number. (Key Net Traffic: 7; Voice: 6; Video: 5;IGMP: 4; Key Data: 3)
OK Click OK to save your changes.
Cancel Click Cancel to exit this screen without saving.
Table 38 QoS > Class Setup Add/Edit (continued)
LABEL DESCRIPTION