User`s guide

Chapter 7 Static Route
ericom D1000 modem User’s Guide
112
7.3.1 IPv6 Static Route Edit
Use this screen to configure the required information for an IPv6 static route. Click Add new static
route or select an IPv6 static route index number and click Edit. The screen shown next appears.
Figure 77 Network Setting > Static Route > IPv6 Static Route: Add/Edit
The following table describes the labels in this screen.
Table 33 Network Setting > Static Route > IPv6 Static Route: Add/Edit
LABEL DESCRIPTION
Destination IPv6
Address
This parameter specifies the IP network address of the final destination. Routing is always
based on network number. If you need to specify a route to a single host, use a prefix
length of 128 in the prefix length field to force the network number to be identical to the
host ID.
IPv6 Prefix Length Enter the address prefix to specify how many most significant bits compose the network
address.
Gateway IPv6
Address
Enter the IPv6 address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway has a route to the
destination network and helps forward packets to their destinations. If a link local address
is used, the interface should also be specified.
PVC IPv6 Address Select the interface through which the traffic is routed.
OK Click this to save your changes.
Cancel Click this to restore your previously saved settings.