User`s guide

G-3000H User’s Guide
Chapter 5 Wireless Configuration 69
Figure 25 Wireless: Bridge/Repeater
The following table describes the bridge labels in this screen.
Table 15 Wireless: Bridge/Repeater
LABEL DESCRIPTIONS
Operating Mode Select Bridge/Repeater in this field to display the screen as shown.
Choose Channel ID Set the operating frequency/channel depending on your particular region.
To manually set the ZyAIR to use a channel, select a channel from the drop-
down list box. Click MAINTENANCE and then the Channel Usage tab to open
the Channel Usage screen to make sure the channel is not already used by
another AP or independent peer-to-peer wireless network.
To have the ZyAIR automatically select a channel, click Scan instead.
Refer to the Wizard Setup chapter for more information on channels.
Scan Click this button to have the ZyAIR automatically scan for and select a channel
with the least interference.
RTS/CTS Threshold (Request To Send) The threshold (number of bytes) for enabling RTS/CTS
handshake. Data with its frame size larger than this value will perform the RTS/
CTS handshake. Setting this attribute to be larger than the maximum MSDU
(MAC service data unit) size turns off the RTS/CTS handshake. Setting this
attribute to zero turns on the RTS/CTS handshake. Enter a value between 800
and 2432.
Fragmentation
Threshold
The threshold (number of bytes) for the fragmentation boundary for directed
messages. It is the maximum data fragment size that can be sent. Enter a
value between 800 and 2432.