User`s guide
G-3000H User’s Guide
Chapter 3 Wizard Setup 47
Figure 12 Wizard 2: Wireless LAN Setup
The following table describes the labels in this screen.
Table 4 Wizard 2: Wireless LAN Setup
LABEL DESCRIPTION
Wireless LAN Setup
Name (SSID) Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for the
wireless LAN.
If you change this field on the ZyAIR, make sure all wireless stations use the
same Name (SSID) in order to access the network.
Choose Channel ID To manually set the ZyAIR to use a channel, select a channel from the drop-
down list box. Open the Channel Usage screen to make sure the channel is
not already used by another AP or independent peer-to-peer wireless network.
To have the ZyAIR automatically select a channel, click Scan instead.
Scan Click this button to have the ZyAIR automatically scan for and select a channel
with the least interference.
WEP Encryption Select Disable allows all wireless computers to communicate with the access
points without any data encryption.
Select 64-bit WEP or 128-bit WEP to allow data encryption.
ASCII Select this option in order to enter ASCII characters as the WEP keys.
Hex Select this option to enter hexadecimal characters as the WEP keys.
The preceding 0x is entered automatically.
Key 1 to Key 4 The WEP keys are used to encrypt data. Both the ZyAIR and the wireless
stations must use the same WEP key for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal
characters ("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal
characters ("0-9", "A-F").
You must configure all four keys, but only one key can be activated at any one
time. The default key is key 1.
Back Click Back to return to the previous screen.
Next Click Next to continue.