User`s guide

G-3000H User’s Guide
Chapter 17 LAN Setup 185
Figure 113 Menu 3.5 Wireless LAN Setup
3 Move the cursor to the Edit Roaming Configuration field. Press [SPACE BAR] to
select Ye s and then press [ENTER]. Menu 3.5.2 – Roaming Configuration displays as
shown next.
Figure 114 Menu 3.5.2 Roaming Configuration
The following table describes the fields in this menu.
Menu 3.5 - Wireless LAN Setup
Edit MAC Address Filter= No
Operating Mode= MESSID Edit Roaming Configuration= Yes
Edit SSID Profile= No
Hide Name (SSID)= No Select SSID Profile= N/A
Channel ID= CH06 2437MHz Edit Bridge Link Configuration= No
RTS Threshold= 2432 Preamble= Long
Frag. Threshold= 2432 802.11 Mode= Mixed
Max. Frame Burst= 650
Breathing LED= Yes
Block Intra-BSS Traffic= No
Output Power= <11b>15dBm/<11g>11dBm
Edit Layer-2 Isolation= No
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.
Menu 3.5.2 - Roaming Configuration
Active= Yes
Port #= 3517
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.
Table 66 Menu 3.5.2 Roaming Configuration
FIELD DESCRIPTION
Active Press [SPACE BAR] and then [ENTER] to select Yes to enable roaming on the
ZyAIR if you have two or more ZyAIRs on the same subnet.
Port # Type the port number to communicate roaming information between access
points. The port number must be the same on all access points. The default is
3517. Make sure this port is not used by other services.
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC
to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.