User`s guide

ZyAIR G-3000 Quick Start Guide
7
Table 1 ZyAIR Front Panel LED Description
LED COLOR STATUS DESCRIPTION
Blinking
The ZyAIR is not ready or is rebooting in AP+Bridge or
Bridge/Repeater mode.
Red
Off
The ZyAIR has a successful reboot in AP+Bridge or
Bridge/Repeater mode.
On
The ZyAIR is set up as an AP+Bridge or Bridge/Repeater.
BDG/RPT
Green
Off
The ZyAIR is set up as an Access Point.
Blinking
(Breathing)
ZyAIR is sending/receiving data through the wireless LAN.
On The ZyAIR is ready, but is not sending/receiving data.
ZyAIR Blue
Off The LED has been disabled in the web configurator or SMT.
Off Neither of the WLAN interfaces is communicating successfully with
another device.
On Both or one of the WLAN interfaces is communicating successfully
with another device.
WLAN
Green
Blinking TX/RX packets are being sent through the ZyAIR.
Off The Ethernet connection is not ready, or has failed.
On The ZyAIR has a successful 10Mbps Ethernet connection. Green
Blinking The ZyAIR is sending/receiving data.
On The ZyAIR has a successful 100Mbps Ethernet connection.
ETHN
Orange
Blinking The ZyAIR is sending/receiving data.
Off The ZyAIR is not receiving power.
On The ZyAIR is receiving power. Green
Blinking The ZyAIR is receiving power but is not ready.
SYS
Orange On The ZyAIR is receiving low power.
Off The ZyAIR is not receiving power.
Green On The ZyAIR is receiving power.
PWR
Red On The ZyAIR is receiving power over the Ethernet cable.