User`s guide

ZyAIR G-1000 Access Point User’s Guide
Remote Management 19-3
Table 19-1 Menu 24.11 Remote Management Control
FIELD DESCRIPTION EXAMPLE
Access Select the access interface (if any) by pressing the [SPACE BAR].
Choices are: LAN only, WLAN only, All or Disable.
LAN only
Secured Client IP The default 0.0.0.0 allows any client to use this service to remotely
manage the ZyAIR. Enter an IP address to restrict access to a client
with a matching IP address.
0.0.0.0
Once you have filled in this menu, press [ENTER] at the prompt "Press ENTER to Confirm or ESC to
Cancel" to save your configuration, or press [ESC] to cancel.
19.4.2 Remote Management Limitations
Remote management over LAN or WLAN will not work when:
1. You have disabled that service in menu 24.11.
2. The IP address in the Secured Client IP field (menu 24.11) does not match the client IP address.
If it does not match, the ZyAIR will disconnect the session immediately.
3. There is already another remote management session of the same type (Telnet, FTP or Web)
running. You may only have one remote management session of the same type running at one
time.
4. There is a web remote management session running with a Telnet session. A Telnet session will be
disconnected if you begin a web session; it will not begin if there already is a web session.
19.5 System Timeout
There is a system timeout of five minutes (300 seconds) for Telnet/web/FTP connections. Your ZyAIR will
automatically log you out if you do nothing in this timeout period, except when it is continuously updating
the status in menu 24.1 or when sys stdio has been changed on the command line.