User`s guide

ZyAIR G-1000 Access Point User’s Guide
19-2 Remote Management
19.4.1 Remote Management Setup
Remote management setup is for managing Telnet, FTP and Web services. You can customize the service
port, access interface and the secured client IP address to enhance security and flexibility.
You may manage your ZyAIR from a remote location via:
the wireless LAN(WLAN only), the LAN only, All (LAN and WLAN) or Disable (neither).
 WLAN only (wireless LAN)  ALL (LAN and WLAN)
 LAN only  Disable (Neither)
Enter 11, from menu 24, to display Menu 24.11 - Remote Management Control (shown next).
Figure 19-2 Menu 24.11 Remote Management Control
The following table describes the fields in this menu.
Table 19-1 Menu 24.11 Remote Management Control
FIELD DESCRIPTION EXAMPLE
Telnet Server
FTP Server
Web Server
SNMP Service
Each of these read-only labels denotes a server or service that you
may use to remotely manage the ZyAIR.
Port This field shows the port number for the remote management service.
You may change the port number for a service if needed, but you
must use the same port number to use that service for remote
management.
Menu 24.11 - Remote Management Control
TELNET Server: Port = 23 Access = LAN only
Secured Client IP = 0.0.0.0
FTP Server: Port = 21 Access = LAN only
Secured Client IP = 0.0.0.0
Web Server: Port = 80 Access = LAN only
Secured Client IP = 0.0.0.0
SNMP Service: Port = 161 Access = ALL
Secured Client IP = 0.0.0.0
Press ENTER to Confirm or ESC to Cancel: