802.11g Wireless 4-port Router User's Guide

ZyAIR G-2000 Plus User’s Guide
Appendix G 408
Configuring What You Want the ZyAIR to Log
Use the sys logs load command to load the log setting buffer that allows you to configure which logs
the ZyAIR is to record.
Use sys logs category followed by a log category and a parameter to decide what to record
Table 151 Log Categories and Available Settings
LOG CATEGORIES AVAILABLE PARAMETERS
8021x 0, 1
access 0, 1, 2, 3
attack 0, 1, 2, 3
error 0, 1, 2, 3
icmp 0, 1
javablocked 0, 1, 2, 3
mten 0, 1
packetfilter 0, 1
remote 0, 1
tcpreset 0, 1
upnp 0, 1
urlblocked 0, 1, 2, 3
urlforward 0, 1
Use 0 to not record logs for that category, 1 to record only logs for that category, 2 to record only
alerts for that category, and
3 to record both logs and alerts for that category.
Use the sys logs save command to store the settings in the ZyAIR (you must do this in order to
record logs).
Displaying Logs
Use the sys logs display command to show all of the logs in the ZyAIR’s log.
Use the sys logs category display command to show the log settings for all of the log categories.
Use the sys logs display [log category] command to show the logs in an individual ZyAIR log
category.
Use the sys logs clear command to erase all of the ZyAIR’s logs.