User`s guide

Ethernet Switch CLI Reference Guide
183
CHAPTER 49
Protocol-based VLAN
Commands
Use these commands to configure protocol based VLANs on the Switch.
49.1 Protocol-based VLAN Overview
Protocol-based VLANs allow you to group traffic based on the Ethernet protocol you specify.
This allows you to assign priority to traffic of the same protocol.
See also Chapter 60 on page 213 for subnet-based VLAN commands and Chapter 66 on page
229 for VLAN commands.
49.2 Command Summary
The following section lists the commands for this feature.
Table 104 protocol-based-vlan Command Summary
COMMAND DESCRIPTION M P
show interfaces config <port-
list> protocol-based-vlan
Displays the protocol based VLAN settings for the specified
port(s).
E3
interface port-channel <port-
list>
Enters subcommand mode for configuring the specified ports. C 13