User`s guide

Dimension ES-3024 Ethernet Switch
Command Examples 26-7
Syntax:
ip arp status
This command displays all interfaces’ IP Address Resolution Protocol (ARP) status. An example is shown next.
Figure 26-13 ip arp status Command Example
26.4.4 ip dhcp Commands
Syntax:
ip dhcp swif0 mode none (This command disables DHCP on the switch interface (swif0))
ip dhcp swif0 status (This command displays the DHCP status on the switch interface
(swif0))
An example is shown next.
Figure 26-14 ip dhcp Command Examples
26.5 Enabling rstp on the Stacking Module
Step 1. First enable RSTP
sys sw rstp bridge enable
Step 2. Then enable RSTP on the stacking port.
sys sw rstp port enable 27
sys sw rstp port enable 28
Step 3. Save the configuration
config save
ES-3024> ip arp status
received 1 badtype 0 bogus addr 0 reqst in 0 replies 1 reqst out 4 bad VID 0
cache hit 29 (0%), cache miss 8366 (99%)
IP-addr Type Time Addr stat iface channel
192.168.1.1 Ethernet 0 00:a0:c5:3f:91:56 43 NULL NULL
num of arp entries= 1
test_mem> ip dhcp swif0 mode none
test_mem> ip dhcp swif0 status
DHCP on iface swif0 is none