User`s guide

Dimension ES-3024 Ethernet Switch
Introduction to CLI 25-15
25.2.4 ip Commands
Table 25-4 Command Summary: ip
COMMAND DESCRIPTION
ip
address [addr]
Displays the host IP address.
alias <iface>
Sets an alias for the specified
interface.
aliasdis <0|1>
Disables/enables the alias for the
specified interface.
arp status
Displays all interfaces’ IP Address
Resolution Protocol status.
httpd debug [on|off]
Enables or disables the HTTP
debug flag.
icmp
status
Displays the ICMP statistics
counter.
discovery <iface> [on|off]
Sets the ICMP router discovery
flag.
ifconfig [iface] [ipaddr] [broadcast
<addr> |mtu <value>|dynamic]
Configures a network interface.
ping <hostid>
Pings a remote host.
route
status
Displays the routing table.
add <dest addr>[/<bits>]
<gateway> [<metric>]
Adds a route.
addiface <dest addr>[/<bits>]
<iface> [<metric>]
Adds an entry to the routing table
for the specified interface.
addprivate <dest
addr>[/<bits>] <gateway>
[<metric>]
Adds a private route.
drop <host addr> [/<bits>]
Drops a route.
status
Displays IP statistic counters.
udp status
Displays the UDP status.
tcp
ceiling [value]
Sets the TCP maximum round trip
time.
floor [value]
Sets the TCP minimum round trip
time.
irtt [value]
Sets the TCP default initial round
trip time.