User`s guide

Dimension ES-3024 Ethernet Switch
25-14 Introduction to CLI
Table 25-2 Command Summary: sys sw
COMMAND DESCRIPTION
display
Displays current run-time trunk
settings.
listView
Displays member list of trunk.
set <group><# ports>
Adds ports to a trunk group.
ingress
set <port> <enable | disable>
Sets ingress check on a port.
get <port>
Gets ingress check state on a
port.
viewAll
Gets ingress check state on all
ports.
learn
enable [port]
Enables address learning on the
port.
disable [port]
Disables address learning on the
port.
display [port]
Displays address learning status.
isolate
disable
Disables port isolation.(All
connected)
port <port> <Port-List (in Hex)>
Sets the port-list which can
connected to the specific port.
enable
Enables port isolation.
mc
set <addr> <port>...
Sets ports to a specific multicast
address
del <addr>
Deletes a specific multicast
address
get <addr>
Shows settings of the multicast
address
vlan
status
Displays VLAN status
type <802.1q | port-based>
Sets VLAN mode
25.2.3 exit Command
Table 25-3 Command Summary: exit
COMMAND DESCRIPTION
exit
Ends the console or telnet
session.