User`s guide

Dimension ES-3024 Ethernet Switch
Introduction to CLI 25-13
Table 25-2 Command Summary: sys sw
COMMAND DESCRIPTION
mirror
The following commands relate to
port mirrors. Port mirroring is
copying traffic from one or all
ports to another or all ports for
external analysis.
applyidx <Class Idx>
<MirrorType=input|output|both>
Apply class to mirroring.
del <Class Idx>
Delete a mirroring class.
disable
Clears current run-time port
mirror settings.
display [class idx]
Displays current run-time port
mirror settings.
set <src port> <src MAC> <src vid>
<dest port> <dest MAC> <dest vid>
Creates a mirror rule using
source/destination port, MAC
address and VLAN group
information. “*” means “any”.
<input|output|both>
Sets the direction of mirrored
traffic.
port <port>
Sets the mirror port (the port
traffic is copied to for analysis).
bw
The following commands relate to
bandwidth control rules.
Bandwidth control means defining
a maximum allowable bandwidth
for traffic flows from specified
source(s) to specified
destination(s).
applyidx <Class Idx> <Max BW>
Apply class to bandwidth control.
del <Class Idx>
Delete a bandwidth control class.
disable
Clears current run-time bandwidth
control rules.
display
Displays current run-time
bandwidth control rules.
set <src port><src mac><src vid><dest
port><dest mac><dest vid><max bw>
Creates a bandwidth control rule
using source/destination port,
MAC address and VLAN group
information. “*” means “any”.
trunk
The following commands relate to
trunking. Trunking is the grouping
of physical ports into one logical
higher-capacity link.
del <id>
Delete a trunk group.
disable
Clears current run-time trunk
settings.