User`s guide

Dimension ES-3024 Ethernet Switch
25-12 Introduction to CLI
Table 25-2 Command Summary: sys sw
COMMAND DESCRIPTION
bmstorm
These commands relate to
broadcast storm control.
disable
Clears current run-time settings
type <dir (ingress/egress)> <type
(broadcast/multicast/both)>
Specifies the type of frames to
limit in the switch; broadcast,
multicast or both.
display [index]
Displays broadcast storm control
ports’ settings
interval [value]
Sets/displays the monitor interval.
set <port><threshold><direction>
Specifies the packet threshold
and direction (ingress/egress) on
the specified port.
del <index>
Disables broadcast storm control
on this port.
mac static
Displays static MAC addresses.
disable
Clears current run-time static
MAC address settings
display [<mac> <vid>]
Displays current run-time static
MAC addresses on the ports.
set <port> <MAC> <vid>
Configures a static MAC address
on the specified port.
del <port> <MAC> <vid>
Deletes a static MAC address on
the specified port.
ageSet <timeout>
Sets aging timeout.
ageView
Displays the aging timeout period.
filter
The following commands relate to
port filters. Port filtering means
sifting traffic from one or all ports
to one or all ports based on the
source and/or destination MAC
addresses and VLAN group.
applyidx <class index>
Apply class to a filter.
del <Class Idx>
Deletes filter class.
disable
Clears current run-time filters.
display
Displays current run-time filter
status.
l2set <src port><src mac><src vid><dest
port><dest mac><dest vid>
Creates a filter rule using
source/destination port, MAC
address and VLAN group
information. “*” means “any”.