User`s guide

Dimension ES-3024 Ethernet Switch
Introduction to CLI 25-9
Table 25-2 Command Summary: sys sw
COMMAND DESCRIPTION
rstp
A
ll “sys sw rstp” commands relate
to rapid STP configuration. Refer
to IEEE Std 802.1w. Use “config
save” to save your configuration
changes.
bridge
enable
Enables RSTP.
disable
Disables RSTP.
priority <priority>
Sets the system priority.
maxage <Max_Age>
Sets the max age timer
hellotime <Hello_Time>
Sets the hello timer.
forwardDelay <Forward_Delay_Time>
Sets the forward delay time
version <STP:0|RSTP:2>
Displays/enables the STP mode;
STP or RSTP. RSTP is the
default used when configuring
STP via web configurator.
port
enable <port_no>
Enables RSTP on this port.
disable <port_no>
Disables RSTP on this port.
pathCost <Port_NO> <Cost|0:Auto>
Sets the specified port’s path
cost.
priority <Port_NO> <Priority>
Sets the specified port’s priority.
edgeport <port_no>
Displays if this port is an edge
port.
p2pLink <Port_NO>
<Auto:2|True:1|False:0>
Sets whether the specified port
can connect to one bridge or
multiple bridges.
mcheck <Port_NO>
Enables the Port Protocol
Migration state machine
(Disabled, Blocking, Listening,
Learning, Forwarding) on the
specified port.
lacp
Refer to IEEE 802.3ad for more
information on link aggregation
control protocol.
agg
Displays ports trunked using
LACP.
port
enable <port_no>
Enables LACP on the specified
port.
disable <port_no>
Disables LACP on the specified
port.