User`s guide

Dimension ES-3024 Ethernet Switch
25-8 Introduction to CLI
Table 25-2 Command Summary: sys sw
COMMAND DESCRIPTION
qos defpri <port> [<0..7>]
Sets the default ingress User
Priority for a port.
map <0..7> [<queue>]
Maps a User Priority to a Traffic
Class.
method <port> <strict | wfq weight1
weight2 weight3 weight4 (Sum of all
weight should be 100)>
Sets QoS method. For WFQ, the
total sum must be 100.
vlan1q
All “sys sw vlan1q” commands
relate to IEEE 802.1Q Tagged
VLAN configuration. Use “config
save” to save your configuration
changes.
port status <port>
Shows a port’s VLAN information.
defaultVID <port><vid>
Sets the default VLAN ID of a
port.
accept <port> <all|tagged|untagged>
Sets the type of frames that a port
accepts.
gvrp <port> <enable|disable>
Enables/disables GVRP on the
specified port.
protocolVID <port><VID><protocol>
Sets protocol-based pvid for the
specific port.
svlan cpu <vlan id>
Sets the VLAN ID of the
management VLAN (CPU).
setentry<name><vid><port><adctl>
<tagctl>
Applies a static VLAN (name,
admin control tag, tag control) to
a port.
delentry <vid>
Deletes the specified (VID) static
VLAN.
active <vid>
Turns on the specified static
VLAN.
inactive <vid>
Turns off the specified static
VLAN.
list
Displays a table of static VLANs.
vlan list <all|vid|start_vid end_vid>
Shows the specified IEEE 802.1Q
Tagged VLAN table.
status
Shows the IEEE 802.1Q tagged
status.
driver
config
Shows the switch’s settings.
count
disp
Shows the switch Network Driver
Interface Specifications (NDIS)
level counters (CPU interface).
clear
Clears the switch NDIS level
counters (CPU interface).