User`s guide

Dimension ES-3024 Ethernet Switch
25-6 Introduction to CLI
Table 25-1 Command Summary: sys
COMMAND DESCRIPTION
pktcnt <port 1-28>
Display port statistic counter
pktcntclear <port 1-28>
Reset port statistic counter
port <portID> <enable | disable>
<Speed> <FlowCtrl>
Port setup
phyread <portID> [<phyAddr>]
Reads PHY register
phywrite <portID> <phyAddr>
<data>
Writes PHY register
dbm mac count [port]
Displays number of MAC
addresses in L2 DBM
dbm mac list [port]
Displays entries in L2 DBM
dbm mac flush [port]
Flushes learned MAC addresses in
the forwarding table.
dbm mac search <MAC> <VID>
Searches the MAC/VID learnt on
which port.
dbm ip list [port]
Displays entries in L3 DBM
log level [0-4]
Sets the log level. Logs displayed
consist of critical, error, warning,
debug and informational messages
in order of severity. Log level “4”
displays all messages; log level “0”
just displays critical messages.
log switch on/off
Outputs messages to the console
or telnet screen.
log list
Lists all IXE log modules.
log module <module_id> <on/off
Enables/disables log on specific
IXE module
log switch < on|off >
Logs all modules to tracelog.
(Current display to console
directly)
memdum <start_addr> <length>
Displays the switch chip’s memory
map for the block specified.
wreg <addr> <value>
Writes to a register.
rreg <addr>
Reads from a register.
show_int_count
Displays the interrupt counter.
clear_int_count
Resets the interrupt counter.
socket
Displays the system socket’s ID #,
type, control block address (PCB),
IP address and port number of
peer device connected to the
socket (Remote Socket) and task
control block (Owner).