User`s guide
Dimension ES-3024 Ethernet Switch
Mirroring 13-3
Table 13-2 Mirroring: Configuring a Mirroring Rule
LABEL DESCRIPTION
Active Make sure to select this check box to activate your rule. You may temporarily deactivate a rule
without deleting it by deselecting this check box.
Name Type a descriptive name for this rule. This is for identification purpose only.
Protocol Select the protocol traffic to which this rule applies.
Source The next fields pertain to the source MAC address and source port.
Ignore Click this check box to ignore any traffic from all source ports.
MAC Address Select Any MAC/VID to apply the rule to all MAC address and VLAN group identification
numbers.
To specify a source, select the second choice and type a MAC address in valid MAC address
format (six hexadecimal character pairs) and then enter the VLAN group identification number.
VID Type the VLAN group identification number.
Port Select the port to which the rule should be applied. You may choose one port only or all ports
(All Ports).
Destination The next three fields pertain to the destination MAC address and destination port.
Ignore Click this check box to ignore any traffic to all destination ports.
MAC Address Select Any MAC/VID to apply the rule to all MAC address and VLAN group identification
numbers.
To specify a destination, select the second choice and type a MAC address in valid MAC
address format (six hexadecimal character pairs) and then enter the VLAN group identification
number.
VID Type the VLAN group identification number.
Port Select the port to which the rule should be applied. You may choose one port only or all ports
(All Ports).
Add Click Add to inset the entry to the summary table below.
Cancel Click Cancel to reset the fields.
Clear Click Clear to start configuring the screen again.
13.2.4 Editing and Viewing a Mirroring Rule
To view a summary of the rule configuration, scroll down to the summary table at the bottom of the Mirroring
screen.
To change the settings of a rule, click a number in the Index field.