User`s guide

Chapter 9 Wireless LAN
EMG2926-Q10A User’s Guide
85
9.5 MAC Filter Screen
The MAC filter screen allows you to configure the EMG2926-Q10A to give exclusive access to
devices (Allow) or exclude devices from accessing the EMG2926-Q10A (Deny). Every Ethernet
device has a unique MAC (Media Access Control) address. The MAC address is assigned at the
factory and consists of six pairs of hexadecimal characters, for example, 00:A0:C5:00:00:02. You
need to know the MAC address of the devices to configure this screen.
To change your EMG2926-Q10A’s MAC filter settings, click Network > Wireless LAN 2.4G/5G >
MAC Filter. The screen appears as shown.
Enable
Bandwidth
Management
for Guest
WLAN
Select this to turn on bandwidth management for the Guest WLAN network.
Maximum
Bandwidth
Enter a number to specify maximum bandwidth the Guest WLAN network can use.
Security Mode
Note: If the WPS function is enabled (default), only No Security and WPA2-PSK are
available in this field.
Select Static WEP, WPA-PSK, WPA, WPA2-PSK or WPA2 to add security on this
wireless network. The wireless clients that want to associate to this network must have
the same wireless security settings as this device. After you select to use a security,
additional options appears in this screen. See Section 9.3 on page 77 for detailed
information on different security modes. Or you can select No Security to allow any
client to associate with this network without authentication.
Apply Click Apply to save your changes with the EMG2926-Q10A.
Cancel Click Cancel to reload the previous configuration for this screen.
Table 33 Network > Wireless LAN 2.4G/5G > More AP: Edit (continued)
LABEL DESCRIPTION