User`s guide

Chapter 8 WAN

EMG2926-Q10A User’s Guide

8.3 Advanced WAN Screen

To change your EMG2926-Q10A’s advanced WAN settings, click Network > WAN > Advanced.

The screen appears as shown.

Figure 44 Network > WAN > Advanced

The following table describes the labels on this screen.

IPv6 DNS server

This is not available when you select IPv4 Only in the IPv6/IPv4 field.

Obtain IPv6 DNS

info Automatically

Select this to have the EMG2926-Q10A get the IPv6 DNS server addresses from the ISP

automatically.

Use the following

Static DNS IPv6

Address

Select this to have the EMG2926-Q10A use the IPv6 DNS server addresses you configure

manually.

IPv6 DNS Server Enter the IPv6 DNS server address assigned by the ISP.

Apply Click Apply to save your changes back to the EMG2926-Q10A.

Cancel Click Cancel to begin configuring this screen afresh.

Table 25 Network > WAN > Internet Connection: PPPoE Encapsulation (continued)

LABEL DESCRIPTION

Table 26 Network > WAN > Advanced

LABEL DESCRIPTION

Multicast Setup

Multicast Select IGMPv1/v2 to enable multicasting. This applies to traffic routed from the

WAN to the LAN.

Select None to disable this feature. This may cause incoming traffic to be dropped or

sent to all connected network devices.

Auto-Subnet Configuration

Enable Auto-IP-

Change mode

Select this option to have the EMG2926-Q10A change its LAN IP address to 10.0.0.1

or 192.168.0.1 accordingly when the EMG2926-Q10A gets a dynamic WAN IP

address in the same subnet as the LAN IP address 192.168.0.1 or 10.0.0.1.

The NAT, DHCP server and firewall functions on the EMG2926-Q10A are still available

in this mode.