User`s guide

Chapter 4 Easy Mode
EMG2926-Q10A User’s Guide
38
The following table describes the labels on this screen.
4.4.6 WPS
Use this screen to add a wireless station to the network using WPS. Click WPS in the Wireless
Security screen to open the following screen.
Figure 29 Wireless Security: WPS
Table 15 Wireless Security
LABEL DESCRIPTION
Wireless Radio Choose whether you want to apply the wireless security to 2.4G Hz or 5G Hz wireless
radio.
Wireless
Network Name
(SSID)
(Service Set IDentity) The SSID identifies the Service Set with which a wireless station is
associated. Wireless stations associating to the access point (AP) must have the same
SSID. Enter a descriptive name (up to 32 keyboard characters) for the wireless LAN.
Security mode Select WPA2-PSK to add security on this wireless network. The wireless clients which
want to associate to this network must have same wireless security settings as this device.
After you select to use a security, additional options appear on this screen.
Select No Security to allow any client to connect to this network without authentication.
Wireless
password
This field appears when you choose wither WPA2-PSK as the security mode.
Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.
Verify password Type the password again to confirm.
Apply Click Apply to save your changes back to the EMG2926-Q10A.
Cancel Click Cancel to close this screen.
WPS Click this to configure the WPS screen.
You can transfer the wireless settings configured here (Wireless Security screen) to
another wireless device that supports WPS.