User`s guide

Chapter 4 Easy Mode
EMG2926-Q10A User’s Guide
37
4.4.5 Wireless Security
Use this screen to configure security for your the wireless LAN. You can enter the SSID and select
the wireless security mode in the following screen. Click the Wireless Security icon in the control
panel of the Easy Mode to open the screen shown below.
Note: You can enable the wireless function of your EMG2926-Q10A by first turning on the
switch in the side panel.
Figure 28 Wireless Security
Subnet Mask Enter the IP subnet mask in this field.
Gateway IP
Address
Enter the gateway IP address in this field.
The following fields are available if you select PPPoE.
Get
automatically
from ISP
Select this radio button if your ISP did not assign you a fixed IP address.
Use Fixed IP
Address
Select this radio button, provided by your ISP to give the EMG2926-Q10A a fixed, unique
IP address.
PPP Username Type the user name given to you by your ISP.
PPP Password Type the password associated with the user name above.
My WAN IP
Address
Type the name of your service provider.
Cancel Click Cancel to close this screen.
Apply Click Apply to save your changes back to the EMG2926-Q10A.
Table 14 Internet Settings (continued)
LABEL DESCRIPTION