User`s guide

Chapter 24 Maintenance
EMG2926-Q10A User’s Guide
155
Note: If you select the incorrect system operation Mode you may not be able to connect
to the Internet.
Access Point Mode Select Access Point Mode if your device bridges traffic between clients on the
same network.
•In Access Point Mode, all Ethernet ports have the same IP address.
• All ports on the rear panel of the device are LAN ports, including the port
labeled WAN. There is no WAN port.
• The DHCP server on your device is disabled.
• Router functions (such as NAT, bandwidth management, remote management,
firewall and so on) are not available when the EMG2926-Q10A is in Access
Point Mode.
• The IP address of the device on the local network is set to 192.168.0.2.
Apply Click Apply to save your settings.
Cancel Click Cancel to return your settings to the default (Router).
Table 74 Maintenance > Sys OP Mode (continued)
LABEL DESCRIPTION