User`s guide

Chapter 1 Introduction
EMG2926-Q10A User’s Guide
15
Figure 4 Front Panel
The following table describes the LEDs and the WPS button.
Table 1 Front panel LEDs and WPS button
LED STATUS DESCRIPTION
WPS Button Press this button for 1 second to set up a wireless connection via WiFi Protected Setup
with another WPS-enabled client. You must press the WPS button on the client side within
120 seconds for a successful connection. See Section 1.6 on page 13 and Section 6.2 on
page 48 for more information on WPS.
Power On The EMG2926-Q10A is receiving power and functioning properly.
Off The EMG2926-Q10A is not receiving power.
WAN On The EMG2926-Q10A’s WAN connection is ready.
Blinking The EMG2926-Q10A is sending/receiving data through the WAN with a
1000Mbps transmission rate.
Off The WAN connection is not ready, or has failed.
Internet On The EMG2926-Q10A has an IP connection but no traffic.
Your device has a WAN IP address (either static or assigned by a DHCP
server), PPP negotiation was successfully completed (if used) and the
connection is up.
Blinking The EMG2926-Q10A is sending or receiving IP traffic.
Off The EMG2926-Q10A does not have an IP connection.
WLAN 2.4/5G On The EMG2926-Q10A is ready, but is not sending/receiving data through the
5G wireless LAN.
Blinking The EMG2926-Q10A is sending/receiving data through the 5G wireless LAN.
The EMG2926-Q10A is negotiating a WPS connection with a wireless client.
Off The wireless LAN is not ready or has failed.
LAN 1-4 On The EMG2926-Q10A’s LAN connection is ready.
Blinking The EMG2926-Q10A is sending/receiving data through the LAN with a
1000Mbps transmission rate.
Off The LAN connection is not ready, or has failed.
USB 1-2 On The EMG2926-Q10A has a USB device installed.
Blinking The EMG2926-Q10A is transmitting and/or receiving data from routers
through an installed USB device.
Off There is no USB device connected to the EMG2926-Q10A.
Power
LAN 1-4
WAN
WPS
USB 1-2
WPS
Button
Internet
WLAN 5G
WLAN 2.4G