User`s guide

Chapter 20 Remote Management
EMG2926-Q10A User’s Guide
133
Use this screen to remotely turn on a device on the network. Click the Management > Remote
MGMT > Wake On LAN to open the following screen.
Figure 93 Management > Remote MGMT > Wake On LAN
The following table describes the labels on this screen.
Table 63 Management > Remote MGMT > Wake On LAN
LABEL DESCRIPTION
Wake On LAN over WAN
Settings
Enable WOL over WAN Select this option to have the EMG2926-Q10A forward a WoL “Magic Packet” to
all devices on the LAN if the packet comes from the WAN or remote network
and uses the port number specified in the Port field. A LAN device whose
hardware supports Wake on LAN then will be powered on if it is turned off
previously.
Port Type a port number from which a WoL packet is forwarded to the LAN.
Wake On LAN
Wake MAC Address Enter the MAC Address of the device on the network that will be turned on.
A MAC address consists of six hexadecimal character pairs.
Start Click this to have the EMG2926-Q10A generate a WoL packet and forward it to
turn the specified device on.
A screen pops up displaying MAC address error if you input the MAC address
incorrectly.
Apply Click Apply to save the setting to the EMG2926-Q10A.
Cancel Click Cancel to begin configuring this screen afresh.