User`s guide

Chapter 20 Remote Management
EMG2926-Q10A User’s Guide
130
The following table describes the labels on this screen.
20.3 SNMP
Simple Network Management Protocol is a protocol used for exchanging management information
between network devices. Your EMG2926-Q10A supports SNMP agent functionality, which allows a
manager station to manage and monitor the EMG2926-Q10A through the network. The EMG2926-
Q10A supports SNMP version one (SNMPv1) and version two (SNMPv2c). The next figure illustrates
an SNMP management operation:
Figure 91 SNMP Management Model
An SNMP managed network consists of two main types of component: agents and a manager.
An agent is a management software module that resides in a managed device (the EMG2926-
Q10A). An agent translates the local management information from the managed device into a
Table 61 Management > Remote Management > WWW
LABEL DESCRIPTION
Port You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Access Status Select the interface(s) through which a computer may access the EMG2926-Q10A
using this service.
Secured Client IP
Address
Select All to allow all computes to access the EMG2926-Q10A.
Otherwise, check Selected and specify the IP address of the computer that can
access the EMG2926-Q10A.
Apply Click Apply to save your customized settings.
Cancel Click Cancel to begin configuring this screen afresh.