User`s guide

EMG2926-Q10A User’s Guide
107
CHAPTER 14
Static Route
14.1 Overview
This chapter shows you how to configure static routes for your EMG2926-Q10A.
The EMG2926-Q10A usually uses the default gateway to route outbound traffic from computers on
the LAN to the Internet. To have the EMG2926-Q10A send data to devices not reachable through
the default gateway, use static routes.
For example, the following figure shows a computer (A) connected to the EMG2926-Q10A’s LAN
interface. The EMG2926-Q10A routes most traffic from A to the Internet through the EMG2926-
Q10A’s default gateway (R1). You create one static route to connect to services offered by your ISP
behind router R2. You create another static route to communicate with a separate network behind
router R3 connected to the LAN.
Figure 73 Example of Static Routing Topology
14.2 IP Static Route Screen
Click Network > Static Route to open the Static Route screen.
WAN
R1
R2
A
R3
LAN