User`s guide

ZyAIR B-5000 User’s Guide
DHCP Parameters 10-3
Table 10-1 Basic Configuration DHCP Parameters
LABEL DESCRIPTION
Trigger DHCP
Service
Select Enable to have your ZyAIR act as a DHCP server and give IP addresses to the
clients. The default is set to Disable.
When DHCP service is enabled, the following items need to be set.
Default Gateway Enter the IP address of the default gateway.
Net Mask Type the subnet mask that the ZyAIR assigns to its clients computer. Consists of four
sets of digits that help divide a network into sub-networks and simplify routing and data
transmission.
DHCP Start IP Start defines the range of IP addresses that will be assigned by the ZyAIR to the client
computer. Type the start IP address for your DHCP server. 192.168.1.240 is the
factory default. The IP address range is 192.168.1.1 to 192.168.1.253.
DHCP End IP Start defines the range of IP addresses that will be assigned by the ZyAIR to the client
computer. Type the end IP address for your DHCP server. 192.168.1.254 is the factory
default. The IP address range is 192.168.1.1 to 192.168.1.253.
Interface Select WLAN or Ethernet.
Table of Fixed Host Entries (Read Only)
Index This is a number given to each new host entry to the pool.
Ethernet
Address
This field specifies the Ethernet address or MAC address of the fixed host entry in the
address pool.
Internet Address This field specifies the Internet address of the fixed host entry in the address pool.
Pool is Empty!
You must click to Add to add entries to the table of fixed host entries; otherwise the
table will be empty.
Add
Click Add for new entries to the pool.
FINISH
Click FINISH to save your changes back to your ZyAIR.
CANCEL
Click CANCEL to begin configuring the DHCP Parameters screen afresh.