User`s guide

ZyAIR B-5000 User’s Guide
6-4 System Setup
Table 6-1 Basic Configuration System Setup
LABEL DESCRIPTION
System Authentication Information
Supervisor ID Enter the username for this user profile. This will determine the username on login.
This ID name can be up to 16 ASCII characters.
Supervisor
Password
Type a password (up to 16 alphanumeric characters) for this user profile. Note that as
you type a password, the screen displays a (*) for each character you type.
Password
Confirm
Retype your new system password for confirmation.
Administration Information
Host Name Type a descriptive name for identification purposes. Some ISPs check this name, so it
is recommended you enter your computer's "Computer name". The default host name
is set to HWLAN.
This name can be up to 16 ASCII characters.
Domain Name Type the domain name (if you know it) here. If you leave this field blank, the ISP may
assign a domain name via DHCP. The domain name entered by you is given priority
over the ISP assigned domain name.
Default Route
IP Address Type the IP address of the remote network or gateway. The gateway is an immediate
neighbor of your ZyAIR that will forward the packet to the destination. On the LAN, the
gateway must be a router on the same segment as your ZyAIR; over the WAN, the
gateway must be the IP address of one of the remote nodes.
DNS Parameters
DNS Server
Address 1, 2, 3
Type the DNS server address here. If you do not configure a DNS server, you must
know the IP address of a computer in order to access it (the default is set as shown).
FINISH
Click FINISH to save your changes back to the ZyAIR.
CANCEL
Click CANCEL to close the System Setup screen without saving any changes.
.