User`s guide

ZyAIR B-5000 User’s Guide
5-14 Bridge Quick Setup
Table 5-8 Quick Setup TCP/IP Settings (Remote Wireless Bridge Mode)
LABEL DESCRIPTION
TCP/IP Settings
Bridge IP Address Type the IP address of your ZyAIR in dotted decimal notation, for example,
192.168.1.1 is the factory default.
Bridge Subnet
Mask
Type the subnet mask assigned to you by your ISP (if given).
Default Gateway Enter the IP address of the default gateway.
DNS Server The ISP dynamically assigns DNS server information (and the ZyAIR's WAN IP
address). The field displays the DNS server IP address that the ISP assigns.
General DHCP Server Parameters
DHCP Service
Select Enable or Disable to activate or deactivate DHCP Service, factory default is
Disabled. When configured as a server, the ZyAIR provides the TCP/IP configuration
for the clients. If this is set to Disable, DHCP service will be disabled and you must
have another DHCP server on your LAN, or else the computers must be manually
configured.
Assign Default
Gateway
Enter the IP address of the default gateway.
Assign net Mask The DHCP server assigns a subnet mask to the PHCP clients.
DHCP Start/End IP DHCP Start IP and End IP provide a range of addresses for your network.
Apply Interface Use the drop-down list to select WLAN to make DHCP services available for the
wireless network or select Ethernet, to make DHCP services available for the wired
network.
Back
Click Back to return to the previous screen.
NEXT
Click NEXT to continue to the wireless setup screen.