User`s guide

ZyAIR B-5000 User’s Guide
5-10 Bridge Quick Setup
Table 5-6 Quick Setup TCP/IP Settings (Central Wireless Router DHCP Mode)
LABEL DESCRIPTION
TCP/IP Settings
Wireless Interface
IP
Type the IP address of your ZyAIR in dotted decimal notation, for example,
192.168.1.1 is the factory default .
Wireless Subnet
Mask
Type the subnet mask assigned to you by your ISP (if given).
NAT (PAT) Network Address Translation (Port Address Translation) allows the translation of an Internet
protocol address used within one network to a different IP address known within another network.
None Select this to disable NAT on all interfaces.
Wireless LAN Select this to activate NAT on the wireless LAN interface.
Ethernet Select this to activate NAT on the Ethernet interface.
General DHCP Server Parameters
DHCP Service
Select Enable or Disable to activate or deactivate DHCP Service, factory default is
Disabled. When configured as a server, the ZyAIR provides the TCP/IP configuration
for the clients. If this is set to Disable, DHCP service will be disabled and you must
have another DHCP server on your LAN, or else the computers must be manually
configured.
Assign Default
Gateway
Enter the IP address of the default gateway.
Assign net Mask The DHCP server assigns a subnet mask to the PHCP clients.
DHCP Start/End IP DHCP Start IP and End IP provide a range of addresses for your network.
Apply Interface Use the drop-down list to select WLAN to make DHCP services available for the
wireless network or select Ethernet, to make DHCP services available for the wired
network.
Back
Click Back to return to the previous screen.
NEXT
Click NEXT to continue to the wireless setup screen.