User`s guide

ZyAIR B-5000 User’s Guide
5-8 Bridge Quick Setup
Table 5-5 Quick Setup TCP/IP Settings (Central Wireless Router PPPoE Mode)
LABEL DESCRIPTION
TCP/IP Settings
Ethernet Interface
IP
Type the IP address of your ZyAIR in dotted decimal notation, for example,
192.168.1.1 is the factory default.
Ethernet Subnet
Mask
Type the subnet mask assigned to you by your ISP (if given).
Wireless Interface
IP
Type the IP address of your ZyAIR in dotted decimal notation, for example,
192.168.1.1 is the factory default .
Wireless Subnet
Mask
Type the subnet mask assigned to you by your ISP (if given).
PPPoE Username Specify your PPPoE username exactly as the ISP provided it to you.
PPPoE Password Specify your PPPoE username exactly as the ISP provided it to you.
Confirm Password Retype the PPPoE password to confirm.
Default Gateway Enter the IP address of the default gateway.
DNS Server The ISP dynamically assigns DNS server information (and the ZyAIR's WAN IP
address). The field displays the DNS server IP address that the ISP assigns.
NAT (PAT) Network Address Translation (Port Address Translation) allows the translation of an Internet
protocol address used within one network to a different IP address known within another network.
None Select this to disable NAT on all interfaces.
Wireless LAN Select this to activate NAT on the wireless LAN interface.
Ethernet Select this to activate NAT on the Ethernet interface.
PPPoE Select this to activate NAT on the PPP over Ethernet interface.
General DHCP Server Parameters
DHCP Service
Select Enable or Disable to activate or deactivate DHCP Service, factory default is
Disabled. When configured as a server, the ZyAIR provides the TCP/IP configuration
for the clients. If this is set to Disable, DHCP service will be disabled and you must
have another DHCP server on your LAN, or else the computers must be manually
configured.
Assign Default
Gateway
Enter the IP address of the default gateway.
Assign net Mask The DHCP server assigns a subnet mask to the PHCP clients.