User`s guide

ZyAIR B-5000 User’s Guide
Access Point Quick Setup 4-7
Table 4-4 Quick Setup TCP/IP Settings (Wireless Access Router PPPoE Mode)
LABEL DESCRIPTION
TCP/IP Settings
Ethernet Interface
IP
Type the IP address of your ZyAIR in dotted decimal notation, for example,
192.168.1.1 is the factory default.
Ethernet Subnet
Mask
Type the subnet mask assigned to you by your ISP (if given).
Wireless Interface
IP
Type the IP address of your ZyAIR in dotted decimal notation, for example,
192.168.1.1 is the factory default.
Wireless Subnet
Mask
Type the subnet mask assigned to you by your ISP (if given).
PPPoE Username Specify your PPPoE user name exactly as the ISP provided it to you.
PPPoE Password Specify your PPPoE user name exactly as the ISP provided it to you.
Confirm Password Retype the PPPoE password to confirm.
NAT (PAT) allows the translation of an Internet protocol address used within one network to a different IP
address known within another network.
None Select this to disable NAT on all interfaces.
Wireless LAN Select this to activate NAT on the wireless LAN interface.
Ethernet Select this to activate NAT on the Ethernet interface.
PPPoE Select this to activate NAT on the PPP over Ethernet interface.
General DHCP Server Parameters
DHCP Service
Select Enable or Disable to activate or deactivate DHCP Service, Disable is the
factory default. When configured as a server, the ZyAIR provides the TCP/IP
configuration for the clients. If this is set to Disable, DHCP service will be disabled
and you must have another DHCP server on your LAN, or else the computers must
be manually configured.
Assign Default
Gateway
Enter the IP address of the default gateway.
Assign net Mask The DHCP server assigns a Subnet Mask.
DHCP Start/End IP DHCP Start IP and End IP provide a range of addresses for your network.
Apply Interface Use the drop-down list to select WLAN to make DHCP services available for the
wireless network or select Ethernet, to make DHCP services available for the wired
network.