User`s guide

ZyAIR B-5000 User’s Guide
24-2 SMT Main Screen
Table 24-1 SMT Main Screen via Telnet or HyperTerminal
Control Description
su
Select su by using the keyboard to go to the supervisor(root) mode. You will need
a supervisor password. The password is “1234” by factory default.
sys_info
Select sys_info by using the keyboard to view information on the current system
status.
ping Select this by using the keyboard to test the connection between any device and
the ZyAIR.
exit Select this by using the keyboard to disconnect from the telnet session.
Privilege
The SMT main menu has USER privileges, allowing access to system information.
If you go to the SU mode, you will have ROOT privileges. This allows you to
access the supervisor mode and configure the SU settings. If you select Enable in
SU mode, you will have CONF privileges. You can configure the ZyAIR from here.
Command This is the command used to change the configuration of the selection.
Message This help message displays information for the associated command above.
24.2 SMT Navigation Controls
The following table shows the keys required to navigate the SMT main menu.
Table 24-2 SMT Navigation Controls
KEY DESCRIPTION
Use the following keys to navigate with the terminal window.
Up/Down or I/K key Use these keys to navigate the cursor up or down and view options.
Right or L or Enter Use these keys to select an item or enter a sub-menu.
Left or J key Use these keys to return to the previous menu.
Home or Ctrl A Move the cursor to the first item of the menu page with these keys.
End or Ctrl A Move the cursor to the last item of the menu page with these keys.
Ctrl Q or F1 Use these keys to show the help page.