User`s guide

ZyAIR B-5000 User’s Guide
Configuration Scenarios 21-17
21.2.10 Remote Wireless Bridge-to-Central Wireless Router
Figure 21-8 Remote Wireless Bridge-to-Central Wireless Router
Step 1. Set the Central Wireless Router/Bridge as a Central Wireless Router; see section 21.2.3
(Wireless Interface IP is 192.168.1.1, Ethernet Interface IP is 192.168.2.1, Turn ‘off’ NAT
(PAT) on the Wireless Interface and turn ‘on’ NAT (PAT) on the Ethernet interface, default
route is 192.168.2.254).
Step 2. Set wireless parameters on the Central Wireless Router: Channel and SSID.
Step 3. Set the DHCP server service on the Central Wireless Router and apply it on Wireless
Interface.
Step 4. Set the Remote Wireless Router/Bridge as a Remote Wireless Bridge; see section 21.2.6
(Bridge Interface IP is 192.168.1.2).
Step 5. Set Wireless parameters on Remote Wireless Bridge: Channel (1) and SSID (wireless), these
parameters must be the same as the Central ZyAIR.
Step 6. The Central Wireless Router assigns IP addresses to PC1 and PC2
Step 7. You can also turn ‘off’ NAT (PAT) on the Central Wireless Router and the two subnets are
transparent.