User`s guide

ZyAIR B-5000 User’s Guide
21-12 Configuration Scenarios
Step 6. You may have to configure two network settings in the Gateway and DNS tabs of each wireless
client’s computer to surf the Internet, or you can enable DHCP server services for all wireless
clients.
Step 7. In general DHCP server parameters, input Assign Default Gateway, Assign Net Mask,
Assign Name Server, DHCP Start IP, DHCP End IP and choose Apply Interface on
HWLAN to make DHCP server services available for your wireless network. Click NEXT.
Step 8. Configure IEEE 802.11b WLAN parameters.
Step 9. Enter the Channel, rts Threshold, frag Threshold, SSID and Station Name that are suitable
for your radio network and then you can clicked radio button to disable WEP or enable 64/128
bit WEP services (default is disable), if WEP is enabled, you must input a corresponding
Default Key index and WEP Key. Click NEXT.
Step 10. Review the configured settings of the ZyAIR.
Step 11. Click the SAVE button to store the changes back to your ZyAIR.
Step 12. Click the RESTART button to take effect the configuration changes.
21.2.6 Configure the ZyAIR as a Remote Wireless Bridge
Step 1. Select BRIDGE as the operating mode, click NEXT.
Step 2. Click QUICK CONFIG, select Remote Wireless Bridge and click NEXT.
Step 3. Enter the Wireless interface IP and Wireless interface Net Mask that are suitable for your
wireless network, enter the Ethernet IP address and Ethernet Net Mask of the Ethernet
interface. Enter the Default Gateway as the Wireless IP address of the ZyAIR and the IP
address of the DNS servers provided by your ISP in the DNS server parameter.
Step 4. You may have to configure two network settings in the Gateway and DNS tabs of your wireless
client’s computer to surf the Internet, or you can enable DHCP server services for all wireless
clients.
Step 5. In General DHCP server parameters, input Assign Default Gateway, Assign Net Mask,
Assign Name Server, DHCP Start IP, DHCP End IP and choose Apply Interface on HWLAN
to made DHCP server services available for your wireless network. Click NEXT.
Step 6. Configure IEEE 802.11b WLAN parameters.
Step 7. Ensure the SSID parameter is the same as the configuration of the root ZyAIR.
Step 8. In this page, enter the Channel, rts Threshold, frag Threshold, SSID and Station Name that
are suitable for your wireless network.
Step 9. Click the radio button to disable WEP or enable 64/128 bit WEP services, if WEP is enabled,
you must input a corresponding Default Key index and WEP Key. Click NEXT.