User`s guide

ZyAIR B-5000 User’s Guide
21-6 Configuration Scenarios
Step 4. Click Disable for Bridge Function.
Step 5. Click FINISH.
Step 6. Click BASIC CONFIG.
Step 7. Select DHCP Parameters and ensure that the DHCP Client Setting is set to Disable.
Step 8. Click FINISH.
Step 9. Click BASIC CONFIG and select Interface Parameters.
Step 10. Select the radio button and select MODIFY to select the interface that you want to change.
Step 11. In interface 1, ensure that the wireless interface Status is set to Active, enter the wireless
interface IP address and wireless interface Net Mask that are suitable for your wireless
network. Turn NAT (PAT) ‘off’.
Step 12. In interface 2, ensure that the Ethernet interface Status is set to Active; enter the Ethernet IP
address and Ethernet Net Mask of the Ethernet interface. Turn NAT (PAT) ‘on’.
Step 13. Click the OK button to return to the Interface Parameters window.
Step 14. Click FINISH.
Make sure interface 3 within Status is set to Disable. In order to enable NAT (PAT)
service, choose the NAT (PAT) in the interface Wireless and Ethernet. For
example, make sure Ethernet interface within NAT (PAT) is set to ‘On’ and
Wireless interface in NAT (PAT) is set to ‘Off’. This means that every
communication through the PPPoE interface is applied to NAT (PAT).
Step 15. Click BASIC CONFIG, and then select System Setup.
Step 16. In System Setup, enter the Default Route as the IP address of the broadband device connected
to the ZyAIR or the IP address of the Gateway in your LAN environment.
Step 17. Enter at least one IP address for the DNS Parameters (Default DNS server 1 is 192.168.2.254)
provided by your ISP in the DNS server parameter. Click FINISH.
Step 18. Set Basic Configuration - Wireless LAN parameters on the ZyAIR: Channel and SSID.
Step 19. Turn on DHCP server on the ZyAIR and assign IP addresses to PC1, PC2 and PC3.
Step 20. Set wireless parameters on client stations PC1, PC2 and PC3: SSID (wireless).