User`s guide

ZyAIR B-5000 User’s Guide
21-4 Configuration Scenarios
Figure 21-2 Wireless Access Router with PPP over Ethernet (PPPoE)
21.1.3 Configure the ZyAIR as a Wireless Access Router with Dynamic IP
Address (DHCP Client)
Step 1. Select ACCESS POINT as the operating mode, click NEXT.
Step 2. Click ADVANCED CONFIG.
Step 3. Select BRIDGING.
Step 4. Click Disable for Bridge Function.
Step 5. Click FINISH.
Step 6. Click BASIC CONFIG.
Step 7. Select Interface Parameters.
Step 8. Click a radio button and select MODIFY to choose the interface that you want to change.
Step 9. In interface 1, ensure that the wireless interface Status is Active and enter the IP address and
wireless interface Net Mask that is suitable for your wireless network. Turn NAT (PAT) ‘off’.
Step 10. In interface 2, Ensure that the ethernet interface Status is set to Active. The other parameters
will be obtained automatically by DHCP from your network environment. Turn NAT (PAT)
‘on’.
Step 11. Click the OK button to return to the Interface Parameters window.