User`s manual

P-660R-F1 Support Notes
45
All contents copyright © 2011 ZyXEL Communications Corporation.
You can edit filter rule to accept or deny LAN packets from/to the IP alias 1/2 go
through the P-660R-F1 by command in CLI:
lan index [index number]
Usage: index number =1 main LAN
2 IP Alias#1
3 IP Alias#2
lan filter <incoming|outgoing> <tcpip|generic> [set#]

lan save
 IP Alias Setup

(1) Edit the first network in Web Configurator, Advanced Setup, Network -> LAN
-> IP/DHCP Setup by configuring the P-660R-F1's first LAN IP address.
Key Settings:
DHCP
Setup
If the P-660R-F1's DHCP server is enabled, the IP pool for the
clients can be any of the three networks.
TCP/IP
Setup
Enter the first LAN IP address for the P-660R-F1. This will create
the first route in the enif0 interface.
(2) Edit the second and third networks in Network -> LAN -> IP Alias by
configuring the P-660R-F1's second and third LAN IP addresses.
Key Settings:
IP Alias 1
Active it and enter the second LAN IP address for the P-660R-F1.