User`s manual

P-660R-F1 Support Notes
29
All contents copyright © 2011 ZyXEL Communications Corporation.
(3) P-660R-F1 setup
Before making a VPN connection from Win9x to WinNT server, you need to
connect P-660R-F1 router to your ISP first.
Enter the IP address of the PPTP server (WinNT server) and the
port number for PPTP as shown below:
‟, fill in the Server IP Address, then press
Save.
When you have finished the above settings, you can ping to the remote Win9x
client from WinNT. This ping command is used to demonstrate that remote the
Win9x can be reached across the Internet. If the Internet connection between two
LANs is achievable, you can place a VPN call from the remote Win9x client.
For example: C:\ping 203.66.113.2
When a dial-up connection to ISP is established, a default gateway is assigned to
the router traffic through that connection. Therefore, the output below shows the
default gateway of the Win9x client after the dial-up connection has been
established.
Before making a VPN connection from the Win9x client to the NT server, you need
to know the exact Internet IP address that the ISP assigns to P-660R-F1 router in
SUA mode and enter this IP address in the VPN dial-up dialog box.
You can check this Internet IP address from PNC Monitor or S Web Configurator,
Status -> WAN Information. If the Internet IP address is a fixed IP address
provided by ISP in SUA mode, then you can a lways use this IP address for
reaching the VPN server.
In the following example, the IP address '140.113.1.225' is dynamically assigned
by ISP. You must enter this IP address in the 'VPN Server' dialog box for reaching
the PPTP server. After the VPN link is established, you can start the network
protocol application such as IP, IPX and NetBEUI.