User`s manual

XP8300/XP8400/SE1100 Simulated PLCBus Connections s 81
Pin 1
PA0 (J10:1)
PA1 (J10:3)
PA2 (J10:5)
PA3 (J10:7)
PA4 (J10:9)
PA5 (J10:11)
PA6 (J10:13)
PA7 (J10:15)
+5 V (J010:1)
/STBX
A3X
A2X
A1X
D2X
D3X
D0X
D1X
+5 V
PIO
Signal
PLCBus
Signal
Picks up VCC, GND,
and PA0–PA7. Leaves
PB0–PB7 available.
J010
PLCBus
Connector
Note that the first two pins of this
connector must hang over the end of
the header. A 20-pin connector is used
because 18-pin connectors are not
available.
J10
!
BL1100
The XP8300 and XP8400 expansion boards may be connected to a BL1100
using an expander cable (Z-World part number 540-0015). Fasten the cables
20-pin connector to the combined headers J010 and J10 as shown in Figure
D-2. Pins 1 and 2 of the expander cable connector must hang over the end
of the combined header. Fasten the cables PLCBus connector to header
P1 or P2 of the expansion board. Note the orientation of pin 1.
Figure D-2. BL1100 Expander Cable Connection
Software for interfacing the BL1100s PIO port to a PLCBus port may be
found in the Dynamic C PBUS
_
LG.LIB library.
Use an external power supply when connecting expansion
boards to the BL1100. There is no provision in the expander
cable to supply +24 V from the controller to header P1 or P2
on the expansion boards.
BL1300
The XP8300 and XP8400 expansion boards may be connected to header P5
on the BL1300 using the same special cable used to connect them to the
BL1000 or to the BL1100, as shown in Figure D-2. The first two pins of
the special cable hang over the end of header P5 as before. However, the
wire leading to pin 1 on the BL1300s header P5 must be cut, and may then
be used to supply +5 V from an external source to the expansion board.
Software from the Dynamic C PBUS_LG.LIB library may be used.
Use an external power supply with expansion boards con-
nected to the BL1300. There is no provision in the special
cable to supply +24 V from the controller to header P1 or P2
on the expansion boards.
!