User Manual

FV828 Rev. A 02/07/23
Page 5
EZ Flush Activation Instruction
Visual Indicator Guide
Status LED
Using supplied hex wrench,remove battery compartment from the
EZ Flush™ unit.
Load batteries into compartment tray and reinstall battery tray
into the EZ Flush unit. See position of batteries on the left. If
installed incorrectly, valve will not work and LED will blink once
every 5 seconds.
Secure tray with hex key. The last three turns of the wrench will
activate the EZ Flush unit. The EZ Flush System is now operational.
Your EZ Flush unit comes preset from the factory. If special
circumstances require adjustment of the activation distance, see
Appendix A – Adjusting Your EZ Flush.
1. Initialization / Power up
Lights up for 1 sec on rst time startup.
2. Target Detection
3 blinks while detecting, then a double blink indicating target
qualied. It will continue to double blink every 30 seconds if
target remains present. After target is no longer detected, EZ-
Flush will ush after 2 seconds.
3. Low Battery / Batteries Orientation Incorrect
1 blink every 5 seconds.