Installation Guide
FV806 Rev. C 06/22/22
Page 14
7. Tighten electronics module assembly with the hydrogenerator
to shank and connect water line(s).
10. Connect sensor cable from spout to monitor.
8. Ensure that sink is clear of tools/debris and is in normal
operating condition. Remove protective lm from sensor lens if one
is present.
9. Turn on water supply(ies).
1. Ensure that the faucet is installed and powered has been applied.
2. Place and hold the Magic Magnet (optional accessory: P6900-AT-MAG) in the upper right hand corner of the sensor as shown. An
indicating light will activate when the magnet is correctly positioned.
3. Wait until the light starts to blink, then remove the magnet. (Faucet has entered the calibration mode.)
4. Place a target at the desired activation range in front of the faucet sensor. (Cardboard, hand, etc.)
5. Wait approximately 10 seconds during the calibration cycle. Do not move the target during this period.
6. Calibration is complete when the light stops blinking.
7. Conrm calibration distance by moving the target back, then slowly forward until the faucet activates at the desired calibration distance.
Sensor Range Adjustment (All congurations when necessary)
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
A A
B B
C C
D D
Anguyen
3/31/2022
D
2 : 1
SHEET 1 OF 1
DRAWN
CHECKED
QA
MFG
APPROVED
DWG NO
TITLE
SIZE
SCALE
REV
N
G
A
M
I
C
E
T
G
A
M
N
G
A
M
I
C
E
T
G
A
M
Z6915-XL
Z6913-XL