Installation Guide
FV806 Rev. A 09/07/21
Page 7
2. Install spout to sink using spout base gasket, plastic mounting
washer, star washer and mounting nut.
Note: Faucet location needs to be within 3 feet radius above
electrical outlet for ACA congurations.
NOTE: Before installation, turn o water supplies to existing faucet and remove faucet if replacing an existing device.
Clean the faucet basin and clear away debris. Flush all supply lines before connecting the faucet. Failure to do so
may result in debris clogging the inlets and/or internal control and mixing valve of the faucet.
1. Carefully screw aerator into spout using included tool.
Take care to not pinch blue o-ring
3. Ensure that slot in plastic washer is facing forward.
Sensor cable should not pass through plastic mounting washer.
Spout Installation Instructions (All Congurations)
Z6913
Z6915
Cover Plate Installation Instructions (All Congurations)
1. (For faucets with -CP4 or -CP8 sux).
Pass sensor connector wire and shank through gasket. Align
gasket with faucet bottom and press rmly together. Pass sensor
connector and shank through cover plate and fasten to the faucet
with the provided screws.