Installation Guide

FV806 Rev. A 09/07/21
Page 11
1.a. Install endpoint on wall surface within 2 feet radius of faucet
with dry wall anchors & screws or doubled sided VHB tape
1.b. For concealed wiring installation, drill 3/16” hole in wall surface
for DC power cable , route wire-end through hole to HW6 unit.
After routing, apply sealant around wire in hole.
Endpoint & Electronic Module Installation Instructions (-W1)
2. Connect endpoint and DC power cable.
5.a. ACA version: Plug in AC adapter to wall outlet.
5.b. Optional HW6 version: Connect supplied inline connector
and hardwire adapter. When securing the CWB wires to the screw
terminals on HW6 unit, the BLACK WITH DASHED MARKINGS
should be connected to the Positive (+) terminal, and the SOLID
BLACK wire should be connected to the Negative (-) terminal.
ACA
BLUE (-)
GREEN/YELLOW
FRAME/SAFETY GROUND
P6000-HW6 WIRING
IN
VAC
(LINE)
BLACK
(NEUTRAL)
WHITE
RED (+)
-CWB
-HW6
4. Connect endpoint and electronics module assembly
using supplied Y cable.
Do not connect Y-cable to the spout.
Endpoint
Electronics Box with
Ceramic Valve
3. Tighten electronics module assembly to shank and connect
water line(s).