User`s guide

Page | 10
WIRELESS SETUP (WISP MODE)
ABOUT WISP MODE
This mode allows the ZuniDigital Travel Connect to use an existing wireless network signal as the WAN (Internet)
connection instead of relying on a wired Broadband signal. This mode is used for providing access to users in
locations where no wired Broadband Internet connection is available, but where a wireless signal exists.
Follow these instructions to setup the ZuniDigital Travel Connect for use in Wireless ISP (WISP) Mode. For the
best results do not place the ZuniDigital Travel Connect near any large metal objects or magnets (like those
found in speakers). Also note that elevating the travel router from the floor will increase wireless broadcast
signal performance and range.
THE SWITCH ON THE TRAVEL ROUTER IS TO SET TO WISP
Step 1 - Attach LAN (Ethernet) Cable
Attach one side of an RJ-45 Ethernet cable into the LAN (Ethernet) port of the Travel Router, and then connect
the other end to the Ethernet port on your computer.